How To Clean A Whirlpool Tub Jets

Jetted tubs accumulate soap scum, biological materials, and other gunk in their jets over fourth dimension. Whether you want to clean a jetted tub that hasn't been used in a while, or keep a tub that you often apply clean, y'all'll need to apply some common household cleaners to have care of that crud. Utilise a special cleaning product to get rid of the more than stubborn natural films, chosen biofilms, that build upward in the jets and plumbing.

1
Fill the tub with hot h2o to ii–3 in (v.one–7.6 cm) above the highest jets. Turn the hot water on and let it make full the tub. Turn it off when the jets are covered past ii–three in (5.1–7.half dozen cm) of water.^[ane]
- Make clean your jetted tub every one-three months if you use your tub daily or several times a week. Clean it at least once every half-dozen months if you only employ it a few times a month.
two
Plow off the air induction valves by turning them fully clockwise. This forces the water to broadcast only in the internal plumbing of the tub to concentrate the flow and clean deeper. Leave them open up if the manufacturer of your tub states to practice and so in the owner's manual.^[2]
- Ever refer to manufacturer'south instructions for cleaning your specific model of tub.
3
Add 2 US tbsp (thirty ml) of dishwashing liquid to the h2o. Apply a low-foaming dishwashing liquid so you don't overflow the tub with bubbles. Use iv tbsp (56.7 thousand) of powdered dish detergent if y'all don't have liquid detergent.^[3]
- The detergent will loosen greasy residual left backside in the jets by soap or bubble bathroom liquid.
four
Pour ¹⁄₂ cup (120 ml) of white vinegar or bleach into the tub. Choose vinegar for a more than eco-friendly choice. Apply bleach if there is whatever mold nowadays in the jets. Only utilize ane or the other and exercise not mix them.^[4]
- Both vinegar and bleach serve to disinfect during the cleaning.
five
Run the jets at full capacity for 10-15 minutes. Set the jets to the highest pressure and turn them on to clean them out. You volition meet whatever gunk caught in the jets coming out into the water.^[5]
- If there is still crud coming out of the jets afterward xv minutes, then keep the jets on until it looks like no more dirt is coming out of them.
half dozen
Bleed the tub and refill information technology with common cold water. Fill the tub up to 2–3 in (5.one–vii.6 cm) above the jets over again, simply with common cold water this time. Cold water is fine for the second bicycle because you are but going to requite the jets a final rinse.^[half-dozen]
- Don't add whatsoever cleaning products to the water this fourth dimension. You lot just desire make clean, cold water for rinsing.
vii
Run the jets for another 10 minutes on loftier ability. This will remove all the last $.25 of remainder that you loosened with the detergent and hot water. Make certain no more than gunk is shooting into the h2o before you turn the jets off.^[vii]
- Let the tub run for another five minutes if it looks like the jets are still blasting out last bits of clay.
eight
Bleed the tub and wipe information technology clean. Let all of the dirty water drain out of the tub. Employ a clean rag to wipe away any residuum that is left on the surface of the tub.^[eight]
- Y'all can employ an old toothbrush to get into the crevices of the jets if in that location is anything lodged in them still after cleaning. Wipe them clean and rinse abroad the debris after doing and so.
EXPERT TIP

James Sears leads the customer happiness team at Neatly, a group of cleaning gurus based in Los Angeles and Orange County, California. James is an expert in all things clean and provides transformative experiences by reducing clutter and renewing your domicile surroundings. James is a electric current Trustee Scholar at the Academy of Southern California.

James Sears
House Cleaning Professional

Try using a non-toxic approach with white vinegar and hot water. Make full the bathtub with hot water, then add together white vinegar and run the jets on high for a few cycles. Bleed the tub, then fill it once more with only water and run the jets to rinse out the vinegar. To deep clean mold and mildew, do the above steps using bleach instead of vinegar. Never use both bleach and vinegar together.

1
Get a biofilm removal liquid and read the instructions on the container. Purchase a biofilm removal liquid at a store that sells Jacuzzi and hot tub cleaning supplies, or online. Biofilm removal liquids are designed specifically to make clean away all the gunk that accumulates inside the plumbing of a jetted tub.^[9]
- Biofilm is a natural film that is created by the buildup of leaner, mold, mildew, and other biological materials.
- Cleaning your jetted tub with biofilm removal liquid is a method of cleaning to exist used on its ain, instead of cleaning your jetted tub with detergent and vinegar or bleach. You tin can use either method to regularly clean your tub effectively.
2
Fill the tub with hot water 2–iii in (five.i–seven.6 cm) above the jets. Turn the hot h2o on and let the tub fill until there is almost 2–iii in (5.1–7.6 cm) of water above the jets. Plow off the water so the tub doesn't fill anymore.
- It's important that the jets are completely covered with water so that, when you plough them on, the motor doesn't go damaged and then they don't spray h2o up into the air.
iii
Add the specified amount of biofilm remover to the water and turn the jets on. Cascade in an amount of the cleaning liquid specified by the product'south instructions. Plow the jets on at their highest power to commencement circulating the cleaner.
- The biofilm cleaner'due south instructions may specify different amounts depending on if it is a regular cleaning or the first cleaning in a while.
four
Alternate running the jets and letting the tub sit down in xxx minute intervals. Always refer to the biofilm remover'due south instructions for whatsoever additional steps. Plow the jets on for 30 minutes, and then turn them off and let the tub sit for 30 minutes, then turn the jets back on for another xxx minutes before you drain it to clean out the plumbing thoroughly.^[10]
- Y'all tin can drain the tub and echo this process if you want to give it an extra good cleaning.
v
Drain your tub and clean any residue effectually the sides. Use a clean rag or sponge to wipe away any gunk left on the surface afterward you drain it. Employ a toothbrush or other small-scale castor to clean away anything that is stuck in or around the jets.
- You lot can repeat the cleaning procedure another time before you lot rinse the tub if it still looks dirty or if yous want to be extra certain you got everything out of the internal plumbing.
6
Refill the tub with cold water and run the jets for x-15 minutes. This will rinse out the last of the gunk from the plumbing and rinse away any remaining biofilm remover. Drain the tub later 10-15 minutes and give it a concluding wipe with a clean rag.^[11]
- Some manufacturers recommend doing this rinsing process after each use of the jetted tub to assistance become rid of soap scum, oils, expressionless pare, and other gunk that builds upwards after each utilize.
- Proceed your jetted tub clean past repeating this whole cleaning process approximately every five uses, regardless of how often you use it.

Add New Question

Question

Can I use a tablet of dishwashing detergent when cleaning a jetted tub?

It may exercise the job, but scrub information technology thoroughly to exist sure it is make clean.
Question

If I simply use the tub as a bathtub will I still need to clean the jets?

Yes, as you lot bleed your tub, a small amount of water is left in the piping of the jets. Every bit the water in the piping evaporates, information technology leaves deposits that creates mold.
Question

We never use the jets in the tub. Is there any mode to kill mold (or keep mold from forming) other than filling the tub, running the jets and refilling the tub?

Neb Soukup

Community Answer

You need to used a jetted tub cleaner to remove harmful contamination inside the plumbing lines. Fifty-fifty if you don't use the jets, water drains dorsum into the lines and is a perfect breeding ground for leaner.
Question

How do I make clean jets in an older tub that have mold on them? I'grand concerned that the water lines backside the jets have mold in them, too. The tub inappreciably always is used for a bath. Just showers.

Bill Soukup

Community Answer

Yous tin can find several proficient jetted tub cleaners on Amazon. These cleaners are designed to remove this type of contamination. Older tubs may take several cleanings since the former contamination may come off in layers and is more hard to remove.
Question

Where practice I get biofilm remover?

Yous tin get it at pool stores, places that sell hot tubs, or places like Home Depot or Lowe's.
Question

How can I remove a tiny ring in my rarely used toilet?

Endeavor a toilet cleaner brand that is fabricated for general use. Or use a scrub and a solution to scrub it off.
Question

How do I make my jets in my tub white again if they are yellow?

Bleach and a toothbrush. Then rinse with cold water. Wear something to protect your skin, and most importantly your optics.
Question

Tin can I use oxygen bleach when cleaning a jetted tub?

As long every bit the chemicals are friendly to safety O-rings, all is OK. The pump has sealing O-rings, as well every bit the individual jets.
Question

Tin my jet tub have a piercing alarm?

Probably not. Y'all might desire to check on the pressure level pump, as it might be spinning a begetting or locked up on something. Piercing sounds warrant immediate investigation!
Question

What tin I utilise if I don't take powdered dishwasher detergent?

Gavin Donnelly

Community Answer

Yous can utilise liquid dish detergent instead of powdered. Just use virtually half the corporeality.

Show more answers

Ask a Question

200 characters left

Include your electronic mail address to get a message when this question is answered.

Submit

Open doors and windows to ventilate the room as much equally possible while using cleaning products. Bleach fumes can exist dangerous in poorly ventilated areas.
Never utilise foaming cleaners or bubble bath in your tub. Bath oils and lotions leave residue in the pipes as well. You should avoid using them in a jetted tub.
Never start the jets unless they are covered by at least a few inches of water. If the jets are exposed, the motor volition be damaged. If the jets are covered but the water is as well shallow, they may spray h2o upwards, bathing your walls instead.
Always refer to the manufacturer's instructions for specific cleaning instructions for your jetted tub.

Things You'll Need

2 U.s.a. tbsp (thirty ml) of dishwashing liquid or iv tbsp (56.7 g) of powdered dish detergent
¹⁄₂ loving cup (120 ml) of white vinegar or bleach
Biofilm remover
Clean rags
Toothbrush (optional)

Virtually this article

Article Summary X

To clean a jetted tub, start by filling it with hot h2o then all of the jets are covered. And then, add two tablespoons of liquid dishwashing detergent to the water, followed past i/2 cup of vinegar or bleach to disinfect the tub. Once you lot've added everything, run the jets for 10-15 minutes and and so drain the tub. When all the water is out, refill the tub with common cold h2o, and run the jets for an additional 10 minutes to rinse out whatsoever residue. Finally, drain the tub and wipe it clean with a rag. To larn how to clean a jetted tub with biofilm remover, curl down!

Did this summary help you lot?

Thanks to all authors for creating a page that has been read 1,163,707 times.